Earthquaker Erupter Fuzz Pedal
Classic Fuzz Tone with Hand-Matched NOS Silicon Transistors |Item ID: EQDERUPV1USA
The Erupter is the result of over two years’ worth of tone-chasing, tweaking, and experimentation in search of the ultimate classic fuzz tone with a big low end (but not too mushy), a biting top end without being too harsh, and just enough output to politely send a tube amp over the top.
Earthquaker used every trick in the book to craft a classic fuzz Device that sounds good with any pickup type, anywhere in the chain (even before a wah pedal!) without any tone-sucking impedance mismatching. Earthquaker build each Erupter with a buffered input section, transformer-based pickup simulation, new production 5% ½ watt carbon composition resistors, metallized polyester film capacitors, Sprague and BC electrolytic capacitors, and low-gain, hand-matched NOS silicon transistors to deliver a well-rounded and defined fuzz tone with just enough pummeling intensity, so you can rock n’ roll all night and still get to bed at a reasonable hour.
Controls & Highlights
- BiasThis control has a center detent for the "perfect" fuzz setting.
|Power Supply:||9 Volt DC 2.1mm negative center|
|Ins - Outs:||1 In- 1 Out|
Warning: This product contains a chemical(s) that is known to the State of California to cause cancer. For more information, go to www.P65Warnings.ca.gov.